F11 opens the project settings F12 does nothing Ctrl a select all in piano roll Ctrl c copy Ctrl b Paste Shift and left click and drag(piano roll(parameters)) set velocities(or other piano roll parameter) all equal to each other for a specific velocity value Alt left click and drag(piano roll(parameters)) set velocities(or other piano roll parameter) all equal to default value(as opposed to setting them to a specified value) Alt left click piano roll note(s) and drag micro nudge/adjust the horizontal location of notes on the grid without having to turn off snap to grid or whatever Alt q Quantize Wrench tool time shift knob micro nudges everything(all notes in piano roll) a little to the right Alt a after selecting note and change time multiplier knob chops up the note into segments of different lengths Alt r, take off pattern mode and adjust velocity knob randomize velocities of selected notes to make it sound more like it was played Alt x brings up faders that allow you to adjust velocities up and down relative to where they already were, center keeps the relative positioning of the velocities but allows you to bring them all up or down at once while multiply exaggerates or lessens dynamics between velocities Alt click resets a parameter to default Alt L allows you to fill in gaps for selected notes(I guess it's like legato(ctrl L) but it brings up menu that allows you to fine tune more idk if there are any other differences) Only with selection after clicking alt L allows you to extend notes based on only the selected notes Alt s make a selected chord "strum".
0 Comments
Leave a Reply. |